![]() Retraction Vertical Lift: 0.We also recommend using a filament cleaner and to use dry filament, or to dry your filament before using it. This printing method uses hardly any plastic due to the small size of the prints, it therefore makes sense to buy good quality plastics. PC-ABS (available here in 1.75mm or 2.85mm).Second inside perimeter would be 70mm/s - 23.34mm/s 46. ![]() ![]() For a 70mm/s main speed and 50 underspeed for outlines: First inside perimeter will be 70mm/s - 11.67mm/s 58.34mm/s. If you set it to 50 for example and you use 3 Perimeters each one will slow down progressively. MG94 ABS (recommend natural, available here in 1.75mm or 2.85mm) Edit: Forgot to explain an important thing.We find that a 3:1 gear ratio works perfectly. We recommend using or updating your printer to use 0.9°/step Nema17 motors. Light coat of UHU for initial layer bed adhesionĪlthough a belt system using 1.8°/step Nema17 motors does produce acceptable results, artefacts from microstepping become quite visible at this scale.E3D V6.1 sock, if you do not have a V6.1, you can upgrade your V6 with this.We recommend using a ring type fan duct like this one. V6.1 block, V6 heatbreak and V6 heatsink with fan.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |